Internal VSB replacement light sensor for plugging into pins 5+6
Product information "Internal VSB replacement light sensor for plugging into pins 5+6"
- Does the device no longer switch off when it gets dark?
- Is the cord wound round the spool the right way round (!)?
- However, short-circuiting pins 3 and 4 with a coin or similar causes the device to switch on, whilst removing the short-circuit causes it to switch off again?
>> The internal light sensor is most likely faulty. Remove the internal sensor using pliers and plug this new internal sensor into pins 5 and 6 on the Doorkeeper
You will need a pair of pliers or side-cutting pliers to remove the internal sensor. Cut the sensor off at the two pins above the circuit board. Make sure that any remaining wires from the old sensor do not touch each other.
Note: If the device is still under warranty, this will be voided if you tamper with it. Please send the device to us for repair if it is still under warranty.
Log in
No reviews found. Share your experiences with others.